CIV Cable -ICOM -ACOM

37.50

2 in stock (can be backordered)

SKU: CIVcable Category:

Description

This is the CIV cable which will control and change between the ICOM radios  and the Acom 2000A  can be made up for any ICOM to any ACOM  with auto band switching 

Not strictly necessary but will deliver positive control if desired 

 

 

 

Additional information

Weight0.4 kg
Specifications

RF output: 1500-2000 W keyed carrier or SSB – no time limit. Constant carrier modes 1500W RF output – no time limit with auxiliary cooling fan.
Frequency coverage: All amateur bands 1.8-24.5 MHz. 28 Mhz only with modification by licensed amateurs.
Bandchange / Tuneup: Initial output matching process in less than 3 secs (typically 0.5 secs). Preset matching process / bandchange takes less than 0.2 second to move to different segment, same band and less than 1 sec for QSY to different band.
Tuning memories: Non-volatile for up to 10 antennas per frequency segment.
Drive power: Typically 50W for 1500W output.
Input impedance: 50 ohms nominal. VSWR <1.5:1.
Output tolerance: Up to 3:1 VSWR (2:1 on 160m) at full rated output before SWR protection circuit actuates. Higher SWR's tolerated at lower output.
Harmonics: At least 50 dB below peak output at 1500W.
Intermodulation: At least 35 dB below peak output at 1500W.
T/R and keying: Vacuum Relay: QSK capable.
Tubes and circuit: 4CX800A/GU74b tetrodes (2); resistive grid, PI-L output with RF negative feedback. Regulated screen grid voltage.
ALC: Negative going, grid derived, -11v max, rear panel adjustable.
Metering: Comprehensive. Remote Control Unit provides flexible monitoring of all amplifier operating parameters.
Protection: Grid and screen current limiting, power inrush (soft-start provided), trip to excessive reflected power, RF arcs, password access protection if needed, correct T/R sequencing, tube exhaust overheat, cover interlock and HV crowbar.
Fault diagnosis: Remote Control Unit display and LED's plus "INFO Box" for 12 most recent events. PC interface (RS-232), plus remote phone line interrogation feature.
Cooling: Full cabinet forced-air. Rubber isolated blower.
Transformer: 3.5 kVA with strip-wound Unisil-H? core.
AC power requirements: 100/120/200/220/240 VAC nominal. 50-60 Hz. 3500VA single phase at full power.
Physical: RF Unit: 17-1/4"W X 7"H X 17-3/4"D
-(440W x 180H x 450D mm).

-RCU: 5-1/4"W X 6-3/4"D X 1" H

-(135 X 25H X 170D mm).

-Shipped in two cartons total weight (96 Lbs/42.5kg). Plug in transformer for ease of installation and transport.

-No controls on RF unit except ON/OFF. RF unit may be located up to 3 metres (20m with optional cable) from RCU.

Manual

https://michaelh192.sg-host.com/wp-content/uploads/2020/12/ACOM-2000A-Manual.pdf

Reviews

There are no reviews yet.

Be the first to review “CIV Cable -ICOM -ACOM”

Your email address will not be published. Required fields are marked *